Routermate CNC Routing System Drilling .75" Aluminum

WATCH VIDEO

This video shows a 4'x 8' Routermate CNC Router
using a milling head and spray coolant system to drill through a piece of .75" thick
aluminum plate. It uses a peck or canned drilling cycle to continuously clear the chip.

Routermate CNC Router cutting through .040" aluminum

WATCH VIDEO

This video shows the Routermate CNC Router cutting through two .040" sheets of
powder coated aluminum at once (total of ... This video shows the Routermate CNC
Router cutting through two .040" sheets of powder coated aluminum at once (total of .080").
The bit is .25" diameter and the coolant spray system is being used. The rough edge is the
plastic protective film peeling up. The aluminum edge underneath is clean.

Routermate CNC Router planing sacrificial surface board

WATCH VIDEO

Routermate 4'x8'CNC Routing system with dust collection system planing the
sacrificial board for an accurate set up. This ... Routermate 4'x8'CNC Routing
system with dust collection system planing the sacrificial board for an accurate set up.
This was done with the base DeWalt router and a 1-1/4 diameter bit.
Call today for a quote (775)673-2200 or toll free (866)571-1066.

Routing Particle Board with 1/4 bit

WATCH VIDEO